-strips are placed in a 20cm long paper at the center of every issue: the strips are cut out of a few cm from the head and foot and be at least 2cm from the back
the facsimile is placed in a clamp is not too tight with the back up and cut the foot closest to
-two wires are prepared in two colors of silk different and the same length: one of the two wires is fixed a needle
-l 'needle with the first thread enters from the outside seam of the fold of the second issue: in this first step is necessary to stop the movement so that the thread remains of a few centimeters above the entrance hole
- from yarn left out of the entrance hole and the second wire creates a double knot
the first wire-covered hole just crossed: in this passage the soul is brought into position and secured by pulling the wire
-second wire is fixed a needle that is brought in to cut the foot of the first issue and soul, this soul slips under the door and before the first head
-August 2 pierces the fold of the third seam of the file (identified thanks to the strip of paper) from the inside height of the chain: pulling the thread, this forms a small loop for the first wire to create the foot of the capital
-the second needle is then used over and before the soul, the first needle can create and outpaced the second-leg
steps continue in this way to all the files until the third last
-third from the file that the needle should form the penultimate leg pierces the file from the inside but you do not take more over the soul, while the wire is left inside the leg moves between cutting penultimate foot of the dossier and the soul, the soul slips under the door and externally at the chain, here you create a double knot between the two ends of wire thereby closing the capital. The steps for the creation of the capital on foot cutting must be repeated to create the capital of the cutting head
The paper strips can be placed in the center of all cases (except for the first last) or be placed every two or (in the case of large volumes) every three installments. In each of these cases it may be necessary to conduct the "clearing rounds" of the yarn around the soul: before being blocked by the leg, the wire that blew the fold seam of a dossier from the inside out and is back and front of the soul above the soul can turn around once, twice, three times the maximum speed of creating compensation. Tours of compensation shall be made if the distance between the center of a case and the next is marked as not to be filled by the simple passage between the two ends of wire between the two colored wires in the creation of the foot: this procedure would put the matter in view of the soul, but must remain hidden from the thread.
can happen, played two rounds of compensation, we were unable to reach the height of the center of the file marked as follows: in this case can be made a third turn around the soul, thus forming the other end of the line a foot in the crease that does not fix the sewing of the file below, but is stabilized by two or three laps around the soul of compensation with the second part of the wire (this is called "false foot") to all ' height of the fold seam where you can join to form the real leg. The need to create fake legs depends on the distance to be bridged between a fold of sewing and the other, the size of the yarn and the soul, the number of turns of compensation to be made: these factors should be carefully evaluated with tests to find a correct formula ensuring the regularity of the interplay between yarn, rounds off, legs, false legs.
Characteristics of an appropriate capital: the position of the soul must be flush with the back cut on the foot or head, the matter should not show up at the sight of the soul, the passage of the wire leaving the fold seam height of the chain to overcome the soul again must be parallel to the fold of the same seam and parallel to other steps, the soul must be firmly attached by thread, which must be tight, the turns of compensation must be regular in number and not more than three per pass .
0 comments:
Post a Comment