The creation of a capital to a simple wire was made on a base of cardboard and a facsimile of stitching up the nerve for the binding with parchment paper
on cardboard backing
- a cardboard rectangle 5cm long and 3cm height is fixed to the 'soul of the capital in the string with paper tape
- ' s needle with the yarn comes from the rear to the front of the card just below the 'soul
- the thread is pulled towards the 'top to divide the length of the wire in equal parts, all' other end of the wire is joined a second needle
- the first part belongs to the first hole blocking 'soul of the capital, then passes around slipping below the string and taking over
- the second part is pulled in order to get under the string and enter the needle from the front to the back of the card near the first hole made: in this step overlaps the first part to form the "foot" of the capital.
- The second part takes you back to overcome the 'soul next to the first part
- The first part comes in with the' needle from front to back of cardboard forming a second leg and back to overcome the 'soul
- We make the same operations for the training of the legs until the end of the card
- The capital is completed by joining the two ends of wire with a double knot
on facsimile:
-paper strips are placed 20cm long at the center of every issue: the strips are cut out of a few cm from the head and foot and be at least 2cm from the back
the facsimile is placed in a clamp is not too tight with the back up and cut the foot closest to
-l 'thread the needle from outside to enter' inner fold of the seam of the second issue: in this first step is necessary to stop the motion so that the yarn came in and what remained outside the fold are the same length
-the thread falls into the hole just crossed: in this passage the soul is brought into position and secured by pulling the wire
-chief of the wire remained outside the fold of the seam is attached to a second needle, and placed between the foot of the first issue of cutting and soul, here slips under the soul and brings before the first head
-August 2 pierces the fold of the third seam file (found thanks to the strip of paper) from the inside height of the chain: pulling the thread, this forms a small loop for creating the first thread Footing the capital
-the second needle is then used above and in front of the soul, the first needle can create and outpaced the second-leg
steps continue in this way to all the files to the third last
-third from the file that the needle should form the penultimate leg pierces the file from the inside but you do not take more over the soul, while the wire is left inside the leg moves between the cutting foot of the penultimate issue of the soul, the soul slips under the door and externally at the chain, here you create a double knot between the two heads wire thus closing the capital.
operations for the creation of the capital on foot cutting must be repeated to create the capital of the cutting head
0 comments:
Post a Comment