Acrylic Brand For Model Cars

leather bindings

Material: a facsimile of stitching up the nerve, indorsatura capitals and two colored wires filled with the severed, two conservative cartoon slightly larger counterguard to 2 mm thick ; a piece of leather and large enough to cover the boxes and the backs of Facsimile creating tuck about 8mm

Procedure:

- nerves are frayed and stuck with the internal part of the mixed glue, fences and left TNT dry, absorbent paper and plastic ensuring solidarity between the body of the book and the dishes

- during the 'drying of nerves, with a chalk mark on the flesh side of the skin of the references and back tuck and proceed fleshing the tuck and the area of \u200b\u200bthe back

- when ' drying of the nerves, the facsimile is placed on a terminal with the back up

- 's indorsatura is brushed with glue mixed: The skin is then properly positioned on the back side of the flower to the' external and pulled the plates with the palms of the hands wide open

- the leather is battened on the back bone and stick with TNT, using tweezers to pluck the nerves proceed from the center to the two plates so as to make them stand out to view

- the facsimile is laid on the work surface with the back plate to the top; plastic is inserted between the internal part of the rear and counterguard

- the dial is brushed on the outside mixed with glue, then glued the leather is tight on the plate, leaving 1cm on each side free to form the tuck, fence and left to dry with paper towels and TNT

- completely dry, the face is laid back on the work surface after removing plastic, and paper towels TNT

- you paste the rest of the leather front panel, the same procedure used to glue the leather back plate

- drying is complete, the non-bonded leather is folded and glued on the internal part of the glue mixture, forming an inner lining, about 8mm

- training of the headset: the skin is not glued on the back is folded and inserted all 'inside of the back behind the capital with the' help of the bone splint

- the tuck team and are trimmed with a scalpel, the excess skin is removed

- bonding of two spurs of cardboard with glue on the internal part of the joint space between the buttresses: this is done to try to counter the 'inevitable slight warping of the quadrant to the 'outside caused by glue used to stick the skin

- counterguard are pasted against the flat to tuck and glue mixture.

Characteristics of a suitable leather bindings: the bite should not be too large, this will cause excessive stresses to counterguard, hides and counterguard on the plates must be taut and have no wrinkles, tuck counterguard must overcome the covered on the plates and not to show the view.